Thermal-Resistant Hose by AC Infinity — Heat-Safe Polypropylene Duct for Thermoforge S7 & T7
ACI-ENV-HOSE-100MM
- Low stock - 5 items left
Pairs well with
Heat your tent, not your gear. The AC Infinity Thermal-Resistant Hose connects to the exhaust port of the Thermoforge T7 and S7 heaters and channels warm air exactly where you want it — with a polypropylene wall that stays cooler than standard layered ducting carrying the same heat. Compresses to about 70 cm for storage, extends to a full 2.4 m when you need reach, and locks to the heater with a counter-clockwise threaded seal that doesn't leak.
Specifications
- The hose runs cooler than standard ducting but is still warm during operation — keep it clear of fabric, plastics, foliage, and pets.
- Fit to the exhaust port only. The Thermoforge intake port is built for standard flexible layered 4" ducting — not this hose.
- Maintain at least 30 cm clearance between the open end and any combustible surface, canopy, or wall.
- Avoid sharp kinks at the heater collar — they restrict airflow and accelerate wear at the threaded join.
- Do not use with the AC Infinity Hydrone dehumidifier — Hydrone uses a 6" connection and works with standard combi ducting.
How to Fit It
Pairs Well With
The 1000W AI-driven VPD heater this hose was built to fit. Sold separately — pair them up for full closed-loop heat control.
4" Layered DuctingStandard 100 mm flexible ducting for the Thermoforge intake port — the side this hose doesn't fit.
Environment ControllersAutomate the heater off temperature and VPD targets so you set it once and walk away.
FAQ
Does this hose fit every Thermoforge model?
No — it's designed specifically for the exhaust port of the Thermoforge T7 and Thermoforge S7. It does not fit the Thermoforge T3 or the Hydrone dehumidifier.
Can I fit it to the intake port?
No. The Thermoforge intake port is built for standard flexible layered 4" / 100 mm ducting. This hose is exhaust-port only.
How far does it extend?
It compresses to roughly 70 cm and stretches out to a full 2.4 m — about four times its packed length. Pull it to the length your run actually needs.
Does the outer surface get hot in use?
Yes, it warms up — but the heat-resistant polypropylene wall runs cooler than standard layered ducting carrying the same airflow. Still keep at least 30 cm clearance from fabric, foliage, and combustibles.
Will it work with my AC Infinity Hydrone?
No. The Hydrone uses a 6" / 150 mm connection and standard combi ducting works fine for it — this hose is sized for the 4" / 100 mm Thermoforge ports only.
Can I cut it shorter to suit my space?
No — it's a one-piece collapsible design. Compress it to whatever length you need rather than cutting; cutting will break the seal and the form-holding structure.
Do you ship Australia-wide?
Yes — we ship to every state. Free shipping on orders over $499* (a few bulky items sit outside the free freight category, hence the asterisk).
Get Heat Where You Want It
Direct, sealed, and built for the Thermoforge — pair this hose with your T7 or S7 and aim warm air exactly at your canopy.